Food Establishment Inspection Report |
||||||||||||||||||||||||||||
Page 1 of ????????? | ||||||||||||||||||||||||||||
|
|
FOODBORNE ILLNESS RISK FACTORS AND PUBLIC HEALTH INTERVENTIONS |
Circle designated compliance status (IN, OUT, N/O, N/A) for each numbered item IN=in compliance OUT=not in compliance N/O=not observed N/A=not applicable Mark "X" in appropriate box for COS and/or R COS=corrected on-site during inspection R=repeat violation |
Risk factors are important practices or procedures identified as the most prevalent contributing factors of foodborne illness or injury. Public health interventions are control measures to prevent foodborne illness or injury. |
|
|
GOOD RETAIL PRACTICES |
Good Retail Practices are preventative measures to control the addition of pathogens, chemicals, and physical objects into foods. Mark "X" in appropriate box for COS and/or R COS=corrected on site during inspectionR=repeat violation |
|
|
IOCI 17-356
![]() |
Food Establishment Inspection Report |
||
Page 2 of ?????? | ||
Establishment: FIRST WATCH | License/Permit #: 010912 | Date: 04/29/2024 |
Water Supply: Community Non-Community Licensed Non-Community Waste Water System: Community On-Site IEPA System |
Sanitizer: | Temperature Logs in Use: |
Location | Method | Sanitizer Type | Concentration (PPM) | Heat(F) |
3-Compartment Sink | Chemical Sanitizer | Quaternary Ammonium | 400 | 0.00 |
LT Dish Machine | Chemical Sanitizer | Chlorine | 50 | 0.00 |
Wiping Cloth Bucket | Chemical Sanitizer | Quaternary Ammonium | 200 | 0.00 |
CFPM Verification (name, expiration date, ID#): | |||
SARAH HENSEL 03/02/2027 95044 |
|||
Presentation Type: | DEMONSTRATION | Number Attended: | 2 |
HACCP Discussed | HACCP Principle | Plan Onsite |
3. Establish the Critical Limit for the CCP | Discussed the HACCP principle of identifying critical control points in your processes such as hot holding at 135 degrees F or above, cold holding at 41 degrees F or below and at freezing for frozen foods and 165 degrees F for reheating. | No |
TEMPERATURE OBSERVATIONS |
Item/Location |
Temp |
Item/Location |
Temp |
Item/Location |
Temp |
EGGS/COOK'S LINE COOLER | 39.00°F | CUT FRESH TOMATOES/REACH-IN COOLER | 41.00°F | CUT FRESH TOMATOES/WALK-IN COOLER | 39.00°F |
ICE CREAM/WALK-IN FREEZER | 0.00°F | SAUSAGE/STEAM TABLE | 181.00°F | SOUP/STEAM TABLE | 142.00°F |
POTATOES/COOKING | 189.00°F |
OBSERVATIONS AND CORRECTIVE ACTIONS |
P=Priority PF=Priority Foundation C=Core R=Repeat |
Item Number |
P/PF/C/R | Code Reference | Violations cited in this report must be corrected within the time frames below. |
36 | C | 4-204.112 (A) |
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. A thermometer is not provided in the warmest part of the two-door upright cooler. Provide a suitable thermometer. CORRECT BY NEXT ROUTINE INSPECTION |
SARAH HENSEL Person In Charge (Signature) |
David Groh Inspector |
Follow-up: Yes No | Follow-up Date: |